Question

 Why when using dish network remote control in UHF to change a channel it goes through many channels before it stops Have the receiver favorites set to all channels Remote works fine in IR mode?

Answer Some remotes can be used in IR or UHF mode but not both. What model is the remote, 21.0 or a different model? When a remote is switched to UHF from IR, it needs to be readdressed to the receiver so... Read More »
http://wiki.answers.com/Q/Why_when_using_dish_network_remote_control_in_UHF_to_change_a...

Top Q&A For: Why when using dish network remote control in U...

Why can't i change channels with dish network remote control?

Do you have fresh batteries in the remote? Even though the buttons at the top of the remote may light up, the batteries may not be strong enough to get the signal to the receiver to complete the op... Read More »
http://wiki.answers.com/Q/Why_can%27t_i_change_channels_with_dish_network_remote_control

I reprogrammed my dish network remote to my tv but now i can not change channels or anything how do i fix this?

A few different DISH Network remote codes for your iLO TV that you can try & one should successfully program your remote are, 569, or 720.
http://wiki.answers.com/Q/I_reprogrammed_my_dish_network_remote_to_my_tv_but_now_i_can_...

How do you change channels on remote control by just hitting on channel number?

These remotes are based on "pin switch" settings matching between the remote and the receiver (ie: electric gates or garage door opener) Your remote has an access door to access its battery and dip... Read More »
http://wiki.answers.com/Q/How_do_you_change_channels_on_remote_control_by_just_hitting_...

How do you change remote control address on dish network receiver?


feedback
loading