Question

 How to disassemble a Jeep Transfer Case?

Answer Got a clunk or rattle in your transfer case, maybe 4wd doesn't work anymore. Does it "Row Hop" around corners? I will show you how to disassemble a Jeep transfer case.
http://www.ehow.com/how_2179550_disassemble-jeep-transfer-case.html

Top Q&A For: How to disassemble a Jeep Transfer Case

What Oil to Use in a Jeep Transfer Case?

The Jeep transfer case oil is the same your car manufacturer recommends for your vehicle transmission. This might be Dexron II, ATF+3 or some other automatic transmission oil. You need to service b... Read More »
http://www.ehow.com/way_5950983_oil-use-jeep-transfer-case.html

How to Fill a Jeep Transfer Case?

A Jeep’s transfer case routes the power produced by the engine to either the two rear wheels, or to all four of the Jeep’s wheels for off-road driving. Within the transfer case are a number of ... Read More »
http://www.ehow.com/how_5945668_fill-jeep-transfer-case.html

How to Remove a Jeep Transfer Case?

Removing the transfer case from your Jeep Wrangler is the first step in replacing or upgrading it. The most common transfer case used in the Jeep is the NP231J 3-speed transfer case. Jeep used this... Read More »
http://www.ehow.com/how_5817602_remove-jeep-transfer-case.html

How to Lower a Jeep XJ Transfer Case?

After installing a lift kit on your Jeep XJ, the angle of the drive-shaft changes. This can cause the drive-shaft to vibrate during acceleration and deceleration because of the steep angle of the d... Read More »
http://www.ehow.com/how_7553498_lower-jeep-xj-transfer-case.html


feedback
loading