Question

 How to Time the Distributor in a 1989 Mustang 5.0?

Answer The EEC IV ignition system used in the 1989 Mustang 5.0 uses an electronic ignition module called a T.F.I. (Thick Film Ignition) module to trigger the ignition coil and provide spark for the engine... Read More »
http://www.ehow.com/how_7789699_time-distributor-1989-mustang-50.html

Top Q&A For: How to Time the Distributor in a 1989 Mustang 5.0

How to Reinstall a 1989 Mustang Distributor?

As the engine in your 1989 Mustang runs it turns the distributor shaft and the ignition rotor on the shafts supplies spark to the plug wires of each cylinder at the proper time. If the distributor'... Read More »
http://www.ehow.com/how_7797285_reinstall-1989-mustang-distributor.html

How to Identify a Distributor Cap & Ignition Coil on an OMC Cobra 1989?

The OMC Cobra is a stern drive motor boat. The OMC Cobra was introduced in 1985 following the open market availability of expired Volvo Penta patents which had previously restricted the use of spec... Read More »
http://www.ehow.com/how_7847832_identify-coil-omc-cobra-1989.html

How to Put in a Mustang Distributor?

A distributor transfers electrical current from the ignition coil to the spark plugs in a timed sequence. The electrical charge then helps the engine complete the combustion process by igniting the... Read More »
http://www.ehow.com/how_7969480_put-mustang-distributor.html

Why are there three wires in a Mustang car distributor?

A Mustang's distributor is responsible for routing high voltage power from the ignition coil to the spark plugs at the proper intervals. Ford's distributor has all the wires expected of any other e... Read More »
http://www.answerbag.com/q_view/1930025


feedback
loading