How to Replace the O2 Sensor in a 1995 Chevy S-10 Blazer?

Answer Your Chevy Blazer has four oxygen sensors attached to the exhaust system. The sensors measure the ratio of oxygen to gasoline being passed through the vehicle. If you notice your gas mileage decrea... Read More »

Top Q&A For: How to Replace the O2 Sensor in a 1995 Chevy S-...

How to Install a Camshaft Position Sensor on a 1995 4WD Chevy Blazer?

The camshaft position sensor on a 1995 4WD Chevrolet Blazer is an important part of the powertrain management system. This sensor is located on the back side of the engine distributor, near the eng... Read More »

How to Replace the AC Blower Fan in a 1995 Chevy S10 Blazer?

The Chevrolet S-10 Blazer was introduced alongside the S-10 pickup in 1982. The 1995 Chevrolet S-10 Blazer was equipped with a 4.3-liter V-6, capable of producing 200-horsepower. The base model 199... Read More »

How to Replace an Oil Pan Seal on a 1995 Chevy Blazer?

The oil pan gasket on your 1995 Chevy Blazer provides a tight seal between the oil pan and the engine block. When this seal becomes worn, oil will leak. Because the oil pan gasket is located on the... Read More »

How Do I Replace an O2 Sensor in a 1998 Chevy Blazer?

The 1998 Chevy Blazer has three oxygen (O2) sensors. Two are located up on the front Y-pipe bolted to the V-6 engine's manifold. These two sensors detect the fuel-to-air mix in the exhaust and tran... Read More »