Question

 How to Replace a Water Valve on a Kenmore Washer?

Answer The hot and cold supply hoses on a Kenmore washer are connected to an electromechanical valve mounted on the back of the washer. This valve turns the water supply to the tub on or off in conjunctio... Read More »
http://www.ehow.com/how_8493694_replace-water-valve-kenmore-washer.html

Top Q&A For: How to Replace a Water Valve on a Kenmore Washer

How Do I Know if My Water Pump Is Bad on My Kenmore Washer?

Washing machines, including those built by Kenmore, have internal pumps. These pumps help drain out the water from the washer tub between the wash, rinse, and spin cycles. If the pump is damaged or... Read More »
http://www.ehow.com/how_12158662_water-pump-bad-kenmore-washer.html

Why does a Kenmore elite dishwasher not let water into the washer?

Why does your Kenmore 60 Series washer not stop filling with water?

Take the cover off where the controls are at and there is a pressure switch with a hose connected to it. It should be round, about 2- 2 1/2 inches in diameter and maybe an inch thick. If your washe... Read More »
http://wiki.answers.com/Q/Why_does_your_Kenmore_60_Series_washer_not_stop_filling_with_...

How to Replace the Pump on a Kenmore Washer?

The pump in your Kenmore washing machine is designed to transfer the water from inside of the wash tub to the drain pipe at the conclusion of a wash cycle. The pump is attached to the front of the ... Read More »
http://www.ehow.com/how_8505402_replace-pump-kenmore-washer.html


feedback
loading