Question

 How to Replace a Prop on a Mercury 50HP?

Answer It is very important to use the proper pitch propeller on your 50-horsepower Mercury outboard. Too low a pitch makes it difficult to accelerate and get the boat on-plane or pull skiers, and will al... Read More »
http://www.ehow.com/how_7839634_replace-prop-mercury-50hp.html

Top Q&A For: How to Replace a Prop on a Mercury 50HP

How to Replace a Mercury PCM?

The powertrain control module, or PCM, in the Mercury Sable reads information sent via voltage from certain sensors to figure the proper fuel flow rate required to maintain the proper air-to-fuel r... Read More »
http://www.ehow.com/how_8080359_replace-mercury-pcm.html

How to Replace a Tie Rod in a Mercury Villager?

When your Mercury Villager just doesn't track straight, even after an alignment, the fault may lay with a faulty tie rod end. The good news is that you can replace the tie rod end yourself, and sav... Read More »
http://www.ehow.com/how_4508692_replace-tie-rod-mercury-villager.html

How to Replace the Fan in a Mercury Cougar?

Your Mercury Cougar may have an electrically operated or a mechanical (belt driven) engine cooling fan. These steps apply to all Mercury Cougar models with an electric engine cooling fan, and can b... Read More »
http://www.ehow.com/how_4520476_replace-fan-mercury-cougar.html

How to Replace a Tie Rod End in a Mercury Villager?

When your tie rod end has too much give or is bent, the steering of your Mercury Villager won't improve, no matter alignments you give it. Replace the tie rod ends, get your Villager aligned, and y... Read More »
http://www.ehow.com/how_4509249_replace-tie-rod-end-mercury.html


feedback
loading