How to Remove the Half Shaft on a Mazda 626?

Answer The Mazda 626 has two half shafts. The half shafts are the front axles of the vehicle. The half shaft on the driver's side secures between the transmission and the brake spindle. The half shaft on ... Read More »

Top Q&A For: How to Remove the Half Shaft on a Mazda 626

CV Half-Shaft Installation on a 1999 Mazda 626?

The Mazda 626 was Mazda's first full size sedan sold in the North American market. While the first generation had rear-wheel drive, the second and all subsequent generations use forward wheel drive... Read More »

How to Remove a Half Shaft?

Front-wheel-drive vehicles use half-shafts that slide into a trans-axle housing in the center of the vehicle motor at the bottom rather than a single axle. The half shafts allow for independent sus... Read More »

How to Remove the Axle Shaft on a 1995 Mazda?

The axle shafts on a 1995 Mazda connect the transmission to the wheels. When the engine runs, it turns the transmission shafts, which then turn the wheels, moving the car forward or rearward. These... Read More »

How do I Remove a Drive Shaft from a 1986 Mazda RX-7?

The driveshaft on a 1986 Mazda RX-7 connects the rear axle to the output shaft on the transmission, and is critical to the operation of the vehicle. Without it, the rear wheels cannot turn freely, ... Read More »