How to Remove the Front Panels of a Kenmore HE3T Washer?

Answer The front panel on a Kenmore HE3T washer is comprised of a lower panel, or toe panel, and an upper panel. To gain access to many of the internal components, you must remove both of these front pane... Read More »

Top Q&A For: How to Remove the Front Panels of a Kenmore HE3...

How to Install a Kenmore HE3t Washer Pump?

The water pump, located behind the toe panel of your Kenmore HE3t washing machine, is used to clear water from the tub at the end of each wash cycle. You might have removed the pump that came with ... Read More »

Clogged Pump on a Kenmore Elite Washer HE3t Flashing an F2 Code?

The display on the Kenmore Elite Washer HE3T flashes codes when it detects an error. If it flashes the F2 code, it can mean there is a clog in the drain pump. If there is a clog, it causes the wash... Read More »

How to Remove a Kenmore HE3t Drain Pump?

The drain pump in your Kenmore HE3t washer is responsible for pumping out the water used to clean your clothes into the standpipe or sink. The pump is used a number of times during each cycle, depe... Read More »

How to Replace a Front Seal on a Kenmore HE3 Washer?

The front seal on the Kenmore HE3 washer is known by several different names, including a bellow, boot or gasket. Replacing the door seal is not difficult, but you must disassemble the machine to g... Read More »