Question

 How to Put a Crank Sensor in a 2003 Altima?

Answer The crankshaft position sensor on the 2003 Altima is a magnetic sensor that uses the teeth on the end of the crankshaft to detect the fluctuation of engine revolutions. When this sensor fails, the ... Read More »
http://www.ehow.com/how_12164350_put-crank-sensor-2003-altima.html

Top Q&A For: How to Put a Crank Sensor in a 2003 Altima

2003 Nissan Altima Crank Shaft Sensor Removal?

The crankshaft sensor on a 2003 Nissan Altima is located on the driver's side rear of the engine between the firewall and the engine. It sits low under the intake manifold and can be seen when look... Read More »
http://www.ehow.com/how_6121998_2003-crank-shaft-sensor-removal.html

How to Install the Crank Position Sensor in a 2002 Altima?

The crankshaft position sensor on the 2002 Nissan Altima is located on the side of the block, near the crankshaft pulley. The wiring harness connector has a three-wire plug-in that leads to the mai... Read More »
http://www.ehow.com/how_7700208_install-position-sensor-2002-altima.html

How to Install a Crank Position Sensor on a 2003 Ford F-350 Diesel?

The crankshaft position sensor on the 2003 Ford F-350 diesel is located behind the crankshaft pulley. It senses the rotation of the crankshaft and sends the information via a voltage signal to the ... Read More »
http://www.ehow.com/how_7768763_install-2003-ford-f350-diesel.html

How to Remove a Crankshaft Sensor from a Nissan Altima 2003?

As emissions became stricter throughout the 1970s, car manufacturers saw their big V-8s barely cresting 150 horsepower, and they knew that changes needed to be made. Entering the 1990s, electronic ... Read More »
http://www.ehow.com/how_12140385_remove-crankshaft-sensor-nissan-altima-2003.html


feedback
loading