How to Change the Rear Transmission Seal on a Ranger?

Answer The rear transmission seal is located between the transmission housing and the transmission extension. The extension covers the overdrive gear. To change a leaky seal, you must disconnect the drive... Read More »

Top Q&A For: How to Change the Rear Transmission Seal on a R...

How to Install the Rear Seal on a Turbo 350 Transmission?

General Motors installed the 350 Turbo Hydra-Matic three-speed automatic transmission in a number of its models between 1964 and 1972. Since these are vintage vehicles, there's is a good chance the... Read More »

How to Change a Transmission Seal?

The transmission seal that is most commonly replaced to prevent leakage is the tail shaft seal. This seals the driveshaft where it attaches to the output shaft of the transmission. It is attached a... Read More »

How Do I Change Transmission Fluid in a Ford Ranger?

Research into the occurrence and impact of bullying estimates that 23 percent of fourth through sixth grade students and 17 percent of sixth through 10th graders have been subject to bullying at so... Read More »

How to Change a Rear Oil Seal on a Ford Inline 6 4.9L?

The Ford straight 6-cylinder 4.9-liter engine utilizes a one-piece rear main seal surrounded by a seal cover. To remove these seals, the transmission must be removed to gain access to the seal. One... Read More »