How Do I Replace an O2 Sensor in a 1998 Chevy Blazer?

Answer The 1998 Chevy Blazer has three oxygen (O2) sensors. Two are located up on the front Y-pipe bolted to the V-6 engine's manifold. These two sensors detect the fuel-to-air mix in the exhaust and tran... Read More »

Top Q&A For: How Do I Replace an O2 Sensor in a 1998 Chevy B...

How to Replace CV Joints in a 1998 Chevy Blazer 4X4?

A CV joint, also referred to as a constant-velocity joint, is one of the components of the drive shaft that allows you to steer the wheels while traveling. If the CV joint begins to malfunction, yo... Read More »

How to Replace the Starter in a 1998 Chevy Blazer?

If your 1998 Chevy Blazer won't start, chances are your starter might be bad. You first have to rule out the battery, fuses, relays and the solenoid, but if you do all that and the problem still ex... Read More »

How to Replace the O2 Sensor in a 1995 Chevy S-10 Blazer?

Your Chevy Blazer has four oxygen sensors attached to the exhaust system. The sensors measure the ratio of oxygen to gasoline being passed through the vehicle. If you notice your gas mileage decrea... Read More »

How to Replace 1998 Chevy Blazer Rear Shocks?

The 1998 Chevrolet Blazer is available in both two- and four-wheel drive configurations. Both use a live rear axle supported by leaf springs and a single shock absorber on each side, attached to th... Read More »