Question

 Computer monitor says "No Input Signal" and goes to power save?

Answer The posbilites are:-# Loose cable, or bent pins on cable.# Loose video card.# burnt out power for the video card chip on mainboard (smells bad).# Video card is dead.The most common cause of this pr... Read More »
http://answers.yahoo.com//question/index?qid=20061109014749AAvWb8D

Top Q&A For: Computer monitor says "No Input Signal" and goe...

Why would my computer monitor is black and says "no signal input" everything else is on?

From the onset there could be dozens of reasons why, but I will go over a few I can think of right now.1. Monitor is defective and is not registering input the VGA plug may have been defective or b... Read More »
http://answers.yahoo.com//question/index?qid=20091125144459AAN6YBd

Ive been given a hp 1502 monitor but when i plug it in it says input signal out of range please help?

Lower the resolution setting of your computer, your monitor cannot display it.set for default grahics setting
http://answers.yahoo.com//question/index?qid=20100115204003AA5GRta

Computer monitor says no input?

either the cable is loose ( the cable from the monitor to the computer), the video card is loose (least likely) or the hard drive has crashed. if the cable from your monitor to the computer is not ... Read More »
http://answers.yahoo.com//question/index?qid=20090602124736AAPJkeK

What does it mean when on my computer screen it says no signal input or cable disconnected?

Try rebooting your computer and powering off your monitor. Check the cable at the computer and at the back of the monitor then power the monitor and your computer back on again. If it still recei... Read More »
http://answers.yahoo.com//question/index?qid=20071003050114AAeSsej


feedback
loading